Brandon's 2012 ISM STI
- Thread starter evans609
- Start date
Getting ready to install
Also got my Perrin Cozy put on
And this was the garbage OBX header that came off. Looks like crap
And this was the final product
hard to get a decent pic while under the car
I was happy with the sound at first but not long after I started to miss the sound of th uel header or boxer rumble also known as
Also got my Perrin Cozy put on
And this was the garbage OBX header that came off. Looks like crap
And this was the final product
hard to get a decent pic while under the car
I was happy with the sound at first but not long after I started to miss the sound of th uel header or boxer rumble also known as
Next I got these little things after an accident backing out of a buddies yard and my front lip hooked in the ground. I ordered new clips but it still didnt bring it to oem looking so I got these to try out. After a year they dry rotted out and I think I actually made it too tight so Im going to try and go with a different size O-ring.
I installed my Cusco catch can and my Password JDM quick release fasteners. The catch can was a simple install. Bolt bracket, bolt can to bracket and run the blowback line. The blowback line was a bit too long so I cut off the extra and put it on the overflow nipple. Here is the results. The catch can worls good but it would be better for a N/A car not turbo or subie in general since we have more then 1 oil blowback line so ill be switching this unit out soon with either a Perrin AOS or Grimmspeed AOS
Then I got my Tomei inlet pipe. I was told the Perrin one was easier to install but it still wasnt too bad. I didnt remove the manifold I just removed the old inlet pipe by cutting 2 inlet lines off the stock and sliding the Tomei one in. Takes a bit of wiggling to get in place.
Well here is the inlet pipe
Well here is the inlet pipe
Then I installed my horns. I tie wrapped the wiring harness to the bumper beam so its out of sight. Would highly recommend the wiring harness and bracket. Also if you drive the car during the winter I would tape the end of the harness so no water gets in there.
This is the horns on the bracket
This is the stock horn next to a Hella horn
The horns installed
The mounting bracket and wiring harness helps a lot!! There was no need to take the front bumper off just reach in through the bottem
This is the horns on the bracket
This is the stock horn next to a Hella horn
The horns installed
The mounting bracket and wiring harness helps a lot!! There was no need to take the front bumper off just reach in through the bottem
Also installed my new side skirts. Looks a lot better now that they aren't wavy anymore. I put a self tapping screw in every 4 inches and used a roll of 3m tape on each side skirt.
Jacking here up and taking the skirts off
The old one and the new one
The row of screws! Lol
Side skirts installed
Jacking here up and taking the skirts off
The old one and the new one
The row of screws! Lol
Side skirts installed
